Specification:
Universally suitable for cars, can cut automatically
Waterproof, self-adhesive, removable, longer life
DIY your own personalized car to make your car more stylish
Placement on the vehicle: left, right, front, back, up
Material: PVC film
Waterproof: Yes
Size: as shown
Color: black, white, red, yellow, blue
How to install:
Clean the part to be pasted;
Peel back the car sticker (please pay attention to the back of the sticker, do not remove the side of the sticker from the entire device)
Place it in the car adjustment position and stick it from one side to the other;
Scrap the stickers to remove air from the stickers;
Discover it and finish.
Note:
Due to manual measurement, please allow 1-10mm deviation.
Installation
Use tools: spray kettle, clean rag, scraper, artistic knife, wind drum
1. Clean the surface that needs to be pasted. Spray the glass water evenly on the surface that needs to be pasted (after cleaning the body, spray water with a sprinkler on the body part that will be pasted) & mdash; & mdash; mainly to reduce the sticker viscosity and facilitate the adjustment of position.
2. After determining the position to be affixed, lift the side of the sticker from right to left [or from top to bottom] and press it on the watches with a rag, then affix it, flatten it with a rag and uncover the bottom paper at the same time.
3. When encountering doorknobs or bump-proof bars, the material should be cut and packed or loaded according to the situation.
4. Adjust it in time. After determining the general position of the figure correctly, scrape water and bubbles repeatedly with the scraper, and scrape obliquely from right to left when using the scraper.
In 5, the door and the sewing part with a knife cut into plastic bags, inward.
6. Try to let the moisture in the car stickers dry completely. If possible, use the air duct to heat and dry them moderately
Strong requirements: do not expose to the sun within 24 hours, and do not wash the car within 48 hours.
Reviews
There are no reviews yet.